Ferroli OMNIA S 3.2 Manuel D'installation, D'utilisation Et D'entretien page 20

3.4 Available static pressure
3.4.1 Heat pump circulator indoor unit
100
90
80
70
60
50
40
30
20
10
0
600 800 1000
The graph provides the available static pressure granted by the internal circulator (P_i) at the maximum speed. The internal circulator speed is managed by the hy-
dronic board in order to insure the correct water temperature difference as in the table below:
ΔT= T
-T
Win Wout
NOTE
For the correct operation of the system, a hydraulic bypass must be provided on the system capable of ensuring sufficient water circulation to avoid the
blocking of the heat pump due to lack of water flow alarm.
This is, for example, essential if the system includes zone valves or thermostatic valves which, if they go into partial or complete closure, would result in
a reduction / lack of water flow with consequent water flow switch alarm and therefore the blocking the heat pump.
EN
86
OMNIA S - Prevalenza utile
Prev_ut 10 [kPa]
Mod. 10
1200 1400 1600 1800
Cooling mode
For all set points
5
Cod. 3541V941 - Rev. 05 - 06/2022
Prev_ut 16 [kPa]
Mod. 16 - 16T
2000 2200 2400 2600
Portata [l/h]
Water flow rate [l/h]
Set point <50°C
5
OMNIA S 3.2
2800 3000 3200 3400
Heating mode
Set point >50°C
8
3600