Publicité
Les langues disponibles
Les langues disponibles
Touch Control
A
B
C
D
E
F
A – Lights Button: Lights are three level (high, medium, low). From stand-by-on mode,
touch once for high, twice for medium, three times for low, four times to cycle back.
B - Delay Off Button: Press the Delay Off Button to enable the ten-minute delay-off
function, no matter at what speed the fan is running at. B button will start blinking
indicating the delay off function is enabled. After ten minutes the fan and lights will
turn off. Delay off function can be disabled by pressing B button, changing the speed,
or pressing the Power Button C.
C - Power Button: Press once to activate all button stand by mode allowing control of
other button functions. All buttons will illuminate indicating stand by mode. Press the
Power Button again to turn the hood off (fan and lights). The stand by mode will remain
active for 30 seconds.
D - Low Speed Button: In stand-by mode: Press once for low speed.
E - Medium Speed Button: In stand-by mode: Press once for medium speed.
F - High Speed Button: In stand-by mode: Press once for high speed.
MESH FILTER CLEAN REMINDER (always enabled): after 60 hours of fan usage, button
A blinks when the hood is in stand-by, indicating it is time to clean the mesh filters. To
Reset the function: with the hood in stand-by, press and hold the B button for 4 to 5
seconds, the A button will stop blinking, and the 60-hour timer will reset.
CHARCOAL FILTER REPLACE REMINDER (disabled by default, must be enabled by user
if recirculating hood): To enable Charcoal Filter Replacement Function hold buttons D
and F simultaneously for four seconds. The A button will quickly flash 3 times indicating
the Charcoal Filter Replacement Function is enabled. After 200 hours of fan usage, the B
button will blink while the hood is on, indicating it is time to replace the charcoal filters.
To Reset the Charcoal Filter Replace Reminder function: Hold the B button for 4 to 5
seconds until it stops flashing, and the 200-hour timer will reset.
Order replacement charcoal filter kit number Z0F-C010 through your local dealer, www.
zephyronline.com, or the Zephyr customer service department.
To disable the Charcoal Filter Replacement function, repeat the enable procedure, the A
button will illuminate for 3 seconds then turn off indicating the Charcoal Filter Replace-
ment Function is disabled.
CLEAN AIR FUNCTIOn (disabled by default, must be enabled by the user). To enable
Clean Air function, with hood in stand by, press and hold button E for 4 to 5 seconds.
The E button will start blinking, the fan will turn on low speed for 10 minutes. After
10 minutes the fan will turn off and the 4-hour timer will begin. The E button led will
continue blinking when Clean Air Function is enabled, even if fan is not on. When Clean
Air function is enabled, every 4 hours of non-fan usage the fan will automatically turn
on at low speed for 10 minutes. After 10 minutes the fan will turn off and the 4-hour
timer will reset.
- 21 -
Publicité
