Publicité
Les langues disponibles
Les langues disponibles
ENGLISH
ATTENTION
Read the instructions contained in this booklet carefully before using the appliance.
Star Progetti cannot assume any responsibility for damage to property or personal
injury resulting from failure to abide by the instructions given in this booklet.
following these instructions will insure a long service life and overall electrical and
mechanical reliability. Keep this instruction booklet in a safeplace.
DESCRIPTION
HELIOSA® SERIE 9 is an extremely versatile heater working with infrared rays. It can be used in different situations
and above all it is a very useful thermal support for your different jobs. Its heat is immediate and the electricity
consumption is very low, it takes a little space although it heats a very wide area. HELIOSA® SERIE 9 is built and
developed with the best quality components in accordance to the prevailing legal regulations and certified for
safety in use.
INSTALLATION TO WALL
Install the heater on the wall at a minimum distance of 0,32 m from the ceiling (see installation examples
pag.43,44,45). The height at which the heaters are normally installed varies from 2,70 to 3,00 m Max (9S22 -
9/1S20W), from 3,40 to 4,00 m Max (99S40 - 99/1S40W).
Wall mounting is the ideal solution to achieve the best results in terms of heat with the reflector at a 45° angle
and the heater perfectly horizontal. The appliance must not be placed immediately below a mains socket.
WIRE GUARD (
a)The wire guard should be used if protection is required (for example sports halls or places where games are
played). In areas where indoor footbal is played, it may be necessary to fit additional external guarding to cope with
the force of impact.
b)The wire guard is simply clipped over the front of the reflector.
c)The wire guard must be installed when the heater is fixed under a height of 2,5 m from the floor level and this
assembly must be done during installation and by a qualified electrician.
d)The HELIOSA® SERIE 9 protective wire guard has been designed to prevent direct access to the heating elements
and must not be removed while the heater is being used.
e)The guard does not guarantee full protection for children or the disabled.
MAINTENANCE OF BULB
(TO BE PERFORMED BY QUALIFIED STAFF OR SPECIALIZED TECHNICIAN)
•the guarantee does not cover replacement or repair of bulb.
• replacement of bulb is to be performed only by professionally qualified personnnel or by a servicing centre.
•remove dust from the reflector and bulb periodically with brush or compressed air for constant HELIOSA® SERIE 9
heat efficiency.
• the replacement bulb must be the same as the bulb supplied with the device.
•replacement with other bulbs may damage the device and cause it to be unsafe. contact Star Progetti or the retail
outlet authorized to sell the replacement bulb, specifying the model and code of the purchased heater.
• the injection point on the bulb (c) must always face outward.
OPERATING INSTRUCTIONS
9S22)
18
Publicité
