Wheel; 3.11.1 Changing The Wheel; Axle Nut; Quick-Release Wheels - Kalkhoff IMPULSE EVO RS Notice Originale

3.11

Wheel

3.11.1 Changing the wheel

3.11.1.1

Axle nut*

Removing the rear wheel
1. Remove the pedelec battery.
2. Change the gear to the one
recommended by the gear
manufacturer for disassembly.
3. Remove the gear shift cable from the
rear wheel.
4. Undo the axle nuts using a 15 mm
spanner, turning anticlockwise.
5. Take off the belt/chain.
6. Remove the rear wheel.
Replacing the rear wheel
1. Attach the belt/chain.
2. Insert the rear wheel centrally in the drop-outs as far as it will go.
3. Re-attach the gear shift cable.
4. If necessary, fasten the brake anchor.
5. Tighten the axle nuts using a 15 mm spanner, turning clockwise.
6. Reinsert the battery.
*dependent on model
Shift cable
For 3. Remove shift cable from rear wheel
Axle nut
For 4. Undo axle nuts

3.11.2 Quick-release wheels

DANGER
Front wheel: The quick-release lever must be
wrong
positioned on the opposite side to the brake disc
(where fitted). If the quick-release lever is on
the same side as the brake disc, there is a risk
that they can clash and lock the front wheel (see
diagram), which can cause a serious accident.
Quick-release skewer and
brake disk collide
All quick-release systems must be correctly tightened before you set off.
Otherwise the components can loosen – if that happens while riding you
could fall off, resulting in serious injuries.
Removing the front wheel
1. Remove the pedelec battery.
2. Open the axle lever by folding it by
180˚. You will now usually be able to
see the word 'OPEN' on the inside of
the lever.
3. Undo the adjustment nut by turning it
slightly anticlockwise.
Original User Guide | Pedelec Impulse Evo RS Version 2
*
Adjustment nut
Quick-release skewer
For 2. Open the quick-release skewer
EN-29