Screw Supports: Shifting And Tilting The Saddle; Twin-Screw Supports: Shifting And Tilting The Saddle; Clamp Attachment: Shifting And Tilting The Saddle - Kalkhoff IMPULSE EVO RS Notice Originale

3.3.1

Screw supports: Shifting and tilting the saddle

1. Loosen the clamping screw by turning it
anticlockwise. Turn the screw completely
two to three times at most or the whole
mechanism could fall apart.
2. Move the saddle backwards or forwards as
required.
3. Tilt the bicycle saddle to the desired angle.
4. Tighten the clamping screw by turning it clockwise with a torque
wrench.
5. Ensure that the newly-tightened saddle does not tip; test it by pressing
down on the front and back alternately.
3.3.2

Twin-screw supports: Shifting and tilting the saddle

DANGER
Screw the clamping screws fully in a straight position in the nuts.
Failure to do so can result in the screws tearing out of the nuts.
correct
Clamping screw
EN-18 Original User Guide | Pedelec Impulse Evo RS Version 2
1. To move the saddle, loosen the front
2. Move the saddle backwards or
For 1. Loosen the clamping screw
3. Tighten the screws using a torque wrench to turn them clockwise.
4. To alter the angle of the saddle, loosen the front screw by turning it
5. Tighten the front screw by the same number of turns.
6. Ensure that the newly-tightened saddle does not tip; test it by pressing
3.3.3
1. Turn the clamping nut clockwise
wrong
1. Move the saddle backwards or
and rear screws by turning them
anticlockwise. Turn the screws
completely two to three times at
most or the whole mechanism could
fall apart.
forwards as required.
anticlockwise. Turn the screw completely two to three times at most or
the whole mechanism could fall apart.
down on the front and back alternately.

Clamp attachment: Shifting and tilting the saddle

to loosen it. You may need to
keep the nut on the other side in
place with a second key.
forwards as required.
For 1. Loosen screws
For 1. Loosen clamping nut