Abus FUBE50061 Manuel D'installation Et D'utilisation page 54

In software version 3.xx.yy and upwards:
•
Arm all
•
Internal arming
•
Disarm all
•
Output z (on, off, switch or pulse)
The button codes transmitted by the wireless key switch are not freely
programmable.
Now continue with installation from point 12 of section 7.
8.7.2. Operating mode
The left button (11) of the wireless key switch is used for arming, and
always transmits the code "Button 1". This button corresponds to button 1
(button A) in the Secvest installer mode menu "Other components 
Wireless control panel  Edit wireless control panel".
The right button (12) of the wireless key switch is used for disarming, and
always transmits the code "Button 4". This button corresponds to button 4
(button D) in the Secvest installer mode menu "Other components 
Wireless control panel  Edit wireless control panel".
The Secvest 2WAY FU800X and Secvest FUAA50XYZ wireless alarm
panels have different factory settings for the button assignment of wireless
control panels. The buttons are assigned according to the labels on the
control panel (FU8110).
By default, the buttons of a wireless control panel for use with
a
Secvest 2WAY FU800X (software version 5.xx.yy) or Secvest
FUAA50XYZ wireless alarm panel are assigned as follows (factory
settings):
Button 1: Arm all
Button 4: Not used
EN 22