Abus FUBE50061 Manuel D'installation Et D'utilisation page 44

1. Operating mode Here you can select from
2. Beep tones
3. User code
4. Time
5. Partitions
6. Pairing mode
You can access the required sub-menu by repeatedly pressing the
programming button (15).
The programming menu will be exited at all menu tiers after approx.
2 seconds if the programming button (15) is not pressed.
Each of the sub-menus as well as pairing mode can be enabled by holding
in the programming button (15). The symbol
confirmation.
operation as a wireless control panel (FU5140)
and wireless info module (FU8200, FUMO50030)
Operation as a 2WAY wireless control panel
(FU8110)
Operation as a wireless control panel
(FUBE50001 with rolling code), factory setting
see section 8.1.
Here, you can switch the signal tones of the
wireless key switch on and off
see section 8.2.
Here, you can program the user code
see section 8.3.
Here, you can change the reception time of the
wireless key switch
see section 8.4.
Here, you can determine the partitions to which the
wireless key switch is assigned and for which user
authorisation is available
in operating mode 1 and 3
see section 8.5.
Here, you can pair your wireless alarm panel with
the wireless key switch. This allows the key switch
to display whether your wireless alarm panel is
armed or disarmed
only in operating mode 1
see section 8.6.2.
EN 12
will then appear for