Switching The Beep Tones On And Off; User Code For The Wireless Key Switch - Abus FUBE50061 Manuel D'installation Et D'utilisation

8.2. Switching the beep tones on and off

Press the programming button (15) twice to access this sub-menu. will
appear on the display. Hold down the button until appears on the
display.
During programming, will appear on the display when the beep tones
are switched on or off, and after approx. 1 second the current setting will be
displayed (e.g. ). This number can then be changed by repeatedly
pressing the button. When is displayed, the beep tones are enabled.
When is displayed, the beep tones on the wireless key switch are
disabled.
When you have reached the desired number, hold down the button until
appears on the display to confirm.

8.3. User code for the wireless key switch

Press the programming button (15) three times. will appear on the
display. Hold down the button until appears on the display.
When setting the user code, the display will show to indicate that the
first digit is being set, and after approx. 1 second the current setting will be
displayed (e.g. ). This number can then be changed by pressing the
button. Each of the 4 or 6 digits in the user code can be numbers between
0 and 9 ( ). The fifth and sixth digits can also
be set to the value .
When you have reached the desired value, hold down the button until
appears on the display to confirm. When you release the button, the display
indicates that the second digit is being set by showing , and you can
proceed as before.
When setting the third digit, appears, when setting the fourth digit
● and the sixth digit ●
appears, the fifth digit
Program all six digits of the user code in this way.
EN 15