Publicité
Les langues disponibles
Les langues disponibles
Using the rotary
commander
The rotary commander works by pressing
buttons and/or rotating controls.
You can also control the optional CD or MD
units with the rotary commander.
By pressing buttons
(the SOURCE and MODE buttons)
(SOURCE)
Each time you press (SOURCE), the
source changes as follows:
TUNER t CD*
t MD*
1
Pressing (MODE) changes the operation
in the following ways;
• Tuner :
FM1 t FM2 t FM3 t MW
t LW
• Tape*
2
:
playback direction
• CD unit*
1
: CD1 t CD2 t ...
• MD unit*
1
: MD1 t MD2 t ...
1
If the corresponding optional equipment is
*
not connected, the item will not appear.
2
If a tape is not inserted, this item will not
*
appear.
16
(MODE)
t TAPE*
1
2
By rotating the control
(the SEEK/AMS control)
Rotate the control and release it to:
•Locate the beginnings of tracks on the
tape. Rotate and hold the control, and
release it to fast-wind the tape. To start
playback while fast-winding the tape,
press (MODE).
•Locate a specific track on a disc. Rotate
and hold the control until you locate the
specific point in a track, then release it to
start playback.
•Tune in stations automatically. Rotate and
hold the control to find a specific station.
By pushing in and rotating the
control (the PRESET/DISC control)
Push in and rotate the control to:
•Receive the stations memorised on the
number buttons.
•Change the disc.
Other operations
Rotate the VOL control to
adjust the volume.
Note
When installing in a car without ACC (accessory)
position on the ignition key switch, press (OFF) for
two seconds to turn off the clock display after
turning off the engine.
Press (ATT) to
attenuate the
sound.
Press (OFF) to turn
off the unit.
Publicité
