Inventum MK351 Mode D'emploi page 10

2
appliance description
1. Lid with sealing ring
2. Handle
3. Controllights (blue/red)
4. Start button for heating and frothing
5. Base
6. Maximum indication for heating milk ­ MAX
7. Maximum indication for frothing milk ­ MAX
8. Whisk (frothing)
9. Mixer (heating)
3
before first use
Before you use the appliance for the first time, please do as follows: Carefully unpack the appliance and remove all the packaging
material. Keep the material (plastic bags and cardboard) out of reach of children. Check the appliance after unpacking for any visible
damage, possible from transportation. Place the appliance on a stable and heat resistant surface.
Clean the lid, the whisk and the mixer with warm soapy water. Dry the parts thoroughly. Make sure that the parts are completely dry.
Wipe the exterior and interior with a soft damp cloth and dry thoroughly. The appliance is only suitable heating and frothing milk.
Never fill the appliance with other drinks.
4
preparing milk foam
Check that the voltage corresponds with what is stated on the information plate. Insert the plug in the socket.
Mount the whisk at the bottom of the milk frother. Fill the milk frother with the required amount of milk. Take note of the lower
maximum indication for frothing milk ­ MAX
much milk. The minimum capacity is 75 ml.
Making hot milk froth
Place the cover and place the milk frother on the power base. Briefly press the button to switch on the milk frother. Both indicator
leds (blue/ red) light up and the whisk starts to rotate. Depending on the amount of milk, the milk frother stops automatically after
approximately 90 seconds. The blue indicator led switches off and the red indicator led continuous to flash for approx. 30 seconds to
indicate that the milk frother is ready.
Making cold milk froth
Place the cover and place the milk frother on the power base. Hold the button down for 1­2 seconds to switch on the milk frother. The
blue indicator led lights up and the whisk starts to rotate. Depending on the amount of milk, the milk frother stops automatically after
approximately 60 seconds. The blue indicator led switches off and the red indicator led continuous to flash for approx. 30 seconds to
indicate that the milk frother is ready.
When the milk frother is ready, remove the cover and pour the milk froth in a mug or cup. Only hold the milk frother by its handle. The
rest of the appliance will be hot. Do not use a spoon or other metal object to scoop out the milk froth. This will damage the coating.
After use, the milk frother should be cleaned as described in chapter CLEANING & MAINTENANCE.
Allow the milk frother to cool for 2 minutes before using it again or rinse the milk frother with cold water. By doing this, you can start
using it again sooner.
10
• English
6
7
8 9
­ 115 ml. Frothing milk expands and the milk frother could overflow when using too
1
2
3
4
5