Control Horn And Servo Arm Settings; Control Surface Direction - Horizon Hobby E-FLITE Turbo Timber Evolution 1.5m Manuel D'utilisation

EN

Control Horn and Servo Arm Settings

The table to the right shows the factory settings for the control horns and servo
arms. Fly the aircraft at factory settings before making changes.
NOTICE: If control throws are changed from the factory settings, the AR637T
gain values may need to be adjusted. Refer to the Spektrum AR637T manual for
adjustment of gain values.
After flying, you may choose to adjust the linkage positions for the desired control
response. See the table to the right.
More control throw

Control Surface Direction

Switch on the transmitter and connect the battery. Use the transmitter to operate
the aileron, elevator, and rudder controls. View the aircraft from the rear when
checking the control directions.
Ailerons
1. Move the aileron stick to the left. The right aileron should move down and the
left aileron up, which will cause the aircraft to bank left.
2. Move the aileron stick to the right. The right aileron should move up and the left
aileron down, which will cause the aircraft to bank right.
Elevators
3. Pull the elevator stick back. The elevator should move up, which will cause the
aircraft to pitch up.
4. Push the elevator stick forward. The elevator should move down, which will
cause the aircraft to pitch down.
Rudder
5. Move the rudder stick to the left. The rudder should move to the left, which will
cause the aircraft to yaw left.
6. Move the rudder stick to the right. The rudder should move to the right, which
will cause the aircraft to yaw right.
12
Less control throw
Flaps
Elevator
Tail wheel
Flaps
Flaps
Horns
Flaps
Elevator
Elevator
Elevator
Elevator
Flaps
Ailerons
Elevator
Rudder
Flaps
Flaps
Flaps
Elevator
Elevator
Aileron stick
Elevator stick
Rudder stick
Turbo Timber Evolution 1.5m
Arms
Not Accessible
Not Accessible