FCC Information
FCC ID: BRWTIARLGTNG1
This equipment complies with FCC and IC radiation exposure limits set forth for
an uncontrolled environment. This equipment should be installed and operated
with minimum distance 20cm between the radiator and/or antenna and your body
(excluding fingers, hands, wrists, ankles and feet). This transmitter must not be co-
located or operating in conjunction with any other antenna or transmitter.
Supplier's Declaration of Conformity
Turbo Timber Evolution (EFL105250/EFL105275)
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
CAUTION: Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
IC Information
IC: 6157A-TIARLGTNG1
CAN ICES-3 (B)/NMB-3(B)
This device contains license-exempt transmitter(s)/receivers(s) that comply with
Innovation, Science, and Economic Development Canada's license-exempt RSS(s).
Operation is subject to the following 2 conditions:
Compliance Information for the European Union
EU Compliance Statement:
Turbo Timber Evolution PNP (EFL105275); Hereby, Horizon Hobby,
LLC declares that the device is in compliance with the following:
EU EMC Directive 2014/30/EU; RoHS 2 Directive 2011/65/EU; RoHS 3
Directive - Amending 2011/65/EU Annex II 2015/863.
Turbo Timber Evolution BNF Basic (EFL105250); Hereby, Horizon Hobby, LLC
declares that the device is in compliance with the following: EU Radio Equipment
Directive 2014/53/EU; RoHS 2 Directive 2011/65/EU; RoHS 3 Directive - Amending
2011/65/EU Annex II 2015/863.
Wireless Frequency Range and Wireless Output Power:
Receiver:
2402-2478MHz / 19.95dBm
The full text of the EU declaration of conformity is available at the following internet
address: https://www.horizonhobby.com/content/support-render-compliance.
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Horizon Hobby, LLC
2904 Research Rd.,
Champaign, IL 61822
Email: compliance@horizonhobby.com
Web: HorizonHobby.com
1. This device may not cause interference.
2. This device must accept any interference, including interference that may
cause undesired operation of the device.
EU Manufacturer of Record:
Horizon Hobby, LLC
2904 Research Road
Champaign, IL 61822 USA
EU Importer of Record:
Horizon Hobby, GmbH
Hanskampring 9
22885 Barsbüttel Germany
WEEE NOTICE:
This appliance is labeled in accordance with European Directive
2012/19/EU concerning waste of electrical and electronic equipment
(WEEE). This label indicates that this product should not be disposed of
with household waste. It should be deposited at an appropriate facility
to enable recovery and recycling.
EN
21