Elkron IRT600 Guide Rapide page 4

III. Using the bases as template, make the holes in the surface.
IV. Insert the anchor bolts if the device is fixed to plaster or
bricks.
V. Screw the base into the anchor bolts.
VI. Reposition the cover on the base inserting the upper
coupling of the cover in the specific slot provided on the
base first.
The detector may be installed either vertically or horizontally or onto
the ceiling. Each method implies different applications, illustrated
below.
Vertical wall mounting:
The detector is designed to cover an 8 metre curtain area when it is installed from 1.4 to 1.7 metres from the ground.

Avoid mounting over 1.8 metres high because this could compromise the correct functionality of the detector.

Horizontal wall mounting:
When mounted horizontally, the detector has a detection coverage of 5 metres and only for vertical movements. It cannot

detect horizontal movements. This feature is only useful for detecting intrusions in case of access from the top, e.g. by
means of skylights or hatches on the roof.
Avoid mounting under 2.2 metres high because this could compromise the correct functionality of the detector.

Ceiling mounting:
Mount the detector on the ceiling to monitor the crossing of an area in front of a

window or a door.
If mounted at a height from 2.4 to 3 m from the ground and oriented downwards,

the detector has a coverage of approximately 5 m from floor level.
Avoid mounting over 4 metres high because this could compromise the correct

functionality of the detector.

The arrows show the intrusion movements which are detected in the
various mounting positions.
Radio frequency of use: 868,6 - 868,7 MHz
Radio power transmitted: 3,01 dBm
Hereby, URMET S.p.A. declares that the radio equipment type: CURTAIN-EFFECT INFRARED DETECTOR IRT600 is in
compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet
address: www.elkron.com.
CLICK ON THE FOLLOWING LINK OF THE ELKRON SITE TO ACCESS THE PRODUCT TECHNICAL SHEET AND
DOWNLOAD THE COMPLETE MANUAL:
DIRECTIVE 2012/19/EU OF THE EUROPEAN PARLIAMENT AND OF THE COUNCIL of 4 July 2012 on waste electrical and
electronic equipment (WEEE).
The symbol of the crossed-out wheeled bin on the product or on its packaging indicates that this product must not be
disposed of with your other household waste.
Instead, it is your responsibility to dispose of your waste equipment by handing it over to a designated collection point
for the recycling of waste electrical and electronic equipment. The separate collection and recycling of your waste
equipment at the time of disposal will help to conserve natural resources and ensure that it is recycled in a manner
that protects human health and the environment.
For more information about where you can drop off your waste equipment for recycling, please contact your local city office,
your household waste disposal service or the shop where you purchased the product.
ELKRON
Tel. +39 011.3986711 - Fax +39 011.3986703
www.elkron.com
8m
SIMPLIFIED EU DECLARATION OF CONFORMITY
– mail to: info@elkron.it
Pre-cut area for
tamper switch
ELKRON is a trademark of URMET S.p.A.
Via Bologna 188/C – 10154 Turin (TO) Italy
www.urmet.com
Hole
arrangement
for fixing on
surface x 2
MADE IN TAIWAN