Kärcher K 2 Power Control Mode D'emploi page 13

5. Optionally use the foam nozzle.
a Connect the foam nozzle to the
detergent tank.
b Insert the foam nozzle into the
high-pressure gun and secure it in
place by turning it 90°.
Recommended cleaning method
1. Spray the detergent sparingly on the
dry surface and let it work for a while
(do not let it dry).
2. Rinse off the loosened dirt with the
high-pressure jet.
After operation with detergent
1. Rinse the device with clear water for
approx. 30 seconds.
Interrupting operation
1. Release the trigger of the high-pres-
sure gun.
When the trigger is released, the de-
vice switches off. The high pressure
in the system is maintained.
2. Lock the trigger of the high-pressure
gun.
3. Set the high-pressure gun with the
spray lance in the parking position.
4. For work breaks longer than 5 min-
utes, switch off the device "0/OFF".
Ending operation
CAUTION
Pressure in the system
Injuries due to uncontrolled water es-
caping under high-pressure.
Only disconnect the high-pressure
hose from the high-pressure gun or the
device if there is no pressure in the
system.
1. Release the trigger of the high-pres-
sure gun.
2. Close the water tap.
3. Press the trigger of the high-pres-
sure gun for 30 seconds.
The pressure still remaining in the
system is released.
4. Release the trigger of the high-pres-
sure gun.
5. Lock the trigger of the high-pressure
gun.
6. Disconnect the device from the wa-
ter supply.
7. Switch off the device "0/OFF".
8. Pull the GFCI plug out of the outlet.
CAUTION
Failure to observe the weight
Risk of injury and damage
Be aware of the weight of the device
during transportation.
Carrying the device
1. Lift the device by the carrying han-
dle, and carry it.
Pulling the device
1. Pull out the transport handle.
2. Pull the device by the transport han-
dle.
Transporting the device in a
3. Secure the device against shifting
and tipping.
English
Transport
vehicle
13