Kärcher K 2 Power Control Mode D'emploi page 11

Water supply
For connected loads, see type plate or
chapter Technical data.
Observe the instructions of the water
supply company.
ATTENTION
Damage due to contaminated water
Contaminated water can damage the
pump and the accessories.
For protection, KÄRCHER recom-
mends the use of the KÄRCHER water
filter (special accessory, order number
4.730-059).
Connection to the water line
ATTENTION
Hose coupling with Aquastop on the
water connection of the device
Damage to the pump
Never use a hose coupling with Aquas-
top on the water connection of the de-
vice.
You can use an Aquastop coupling on
the tap.
1. Screw the supplied hose coupling
on to the end of your garden hose.
2. Attach the garden hose to the cou-
pling for the water connection.
3. Connect the garden hose to the wa-
ter line.
4. Open the water tap fully.
ATTENTION
Dry running of pump
Damage to the device
If the device does not build up any
pressure within 2 minutes, switch off
the device and proceed according to
the instructions in chapter Trouble-
shooting guide.
Power Control System
Note
The sensitivity of materials can vary
greatly depending on age and condi-
tion. The recommendations are there-
fore not binding.
Dis- Pressure
play level
HARD
MEDIUM Cars / motorcycles,
SOFT
MIX
English
Operation
Recommended for
e.g.
Stone terraces
made of paving
stones or washed
concrete, asphalt,
metal surfaces, gar-
den utensils (wheel-
barrow, spade, etc.)
brick surfaces, plas-
tered walls, plastic
furniture
Wooden surfaces,
bicycle, sandstone
surfaces, rattan fur-
niture
Operation with de-
tergent
11