Télécharger Imprimer la page

Amprobe VPC-10A Manuel De L'utilisateur page 14

Testeur de tension et de continuité

Publicité

Les langues disponibles

Les langues disponibles

MAINTENANCE
W
Caution
- To prevent damage to the VPC-10A:
• Do not attempt to repair or service the VPC-10A unless qualified to do so.
• Make sure that the relevant calibration, performance tests, and service
information is being utilized.
• Do not use abrasives or solvents.
Cleaning
The only maintenance the VPC-10A requires is inspection and cleaning.
Periodically wipe the case with a mild solution of detergent and water.
Apply sparingly with a soft cloth and allow time to dry completely before
using. Do not use aromatic hydrocarbons, gasoline or chlorinated solvents
for cleaning.
Replacing the Battery
Replace the batteries immediately if the continuity LED doesn't turn on
when touching both probes together.
Warning
W
• To avoid electric shock, disconnect the test leads from the source before
opening the VPC-10A for battery replacement.
• To avoid false readings, which could lead to possible electric shock or
personal injury, replace the battery as soon as the battery is low or
dead.
The VPC-10A uses three 1.5V batteries. To replace the batteries, follow these
steps and refer to Figure 6:
1. Disconnect test leads from any power source.
2. Place the VPC-10A face down on a non-abrasive surface and loosen the
battery-door screw with a Phillips screwdriver.
3. Lift the battery cover away from the VPC-10A.
4. Replace the battery as shown in Figure 6. Observe the battery polarity
shown in the battery compartment.
5. Secure the battery cover back in position with the screw.
All manuals and user guides at all-guides.com
10

Publicité

loading