Publicité
Les langues disponibles
Les langues disponibles
INSTALL THE PADS (REV™ SYSTEM)
CAUTION!
Turn the machine OFF at the power switch, before changing the pads, and before opening any access panels.
1
Make sure the Scrub Deck is in the RAISED position. Make sure the Power Switch (H) is off.
2
See Figure 2-4. Remove both Side Blade Assemblies (AA). NOTE: The blade assemblies are held in place by two large Knobs (BB).
Loosen these knobs and slide the Blade Assemblies (AA) forward slightly and then off of the Scrub Deck.
3
Daily Scrubbing: Slide a daily scrubbing pad (AE) or Microfiber Pad (AB) under each pad driver, center it on the fixed pad driver (AC) and
lift it upwards and press it onto the harpoon face of the pad driver.
4
Floor Finish Removal: Install a new red pad (AE) to each pad driver (AC) as described in step 3 above. If using the optional double sided
Velcro (AF), attach it to the center of maroon SPP pad (AD) and slide this assembly under the red pad and center it and then press upwards
to attach this assembly to the red pad. If the optional double sided Velcro is not used, install a new red as described in step 3 above and
place a new maroon SPP pad on the floor centered on the red pad. Lower the deck to the floor on top of the maroon SPP pad and check that
it is centered.
NOTE: Never attach a maroon SPP pad directly to the pad driver, damage to the pad driver will result requiring replacement.
NOTE: Do not use the Automatic Brush Install Feature (Brush Install Switch (K)) in an attempt to install pads.
FIGURE 2-4
BB
AE
AF
AD
9/2022
INSTRUCTIONS FOR USE
AC
56091272 - Advance SC4000
ENGLISH - A
BB
AA
AB
A - 19
Publicité
