Horizon Fitness EX59 Manuel Du Propriétaire page 6

ASSEMBLY STEP 5
CONSOLE MAST
CONSOLE MAST BOOT
U
LOWER LINK ARM
10
HARDWARE BAG 5 CONTENTS:
R S
Bolt Spring washer
Φ8.2
M8
Qty:2 Qty:2
TOP CAP
T
Flat washer
Φ8.2
Qty:2
A Open HARDWARE BAG 5.
B Slide LOWER LINK ARM into bottom end
of LOWER HANDLEBAR.
LOWER HANDLEBAR
C Secure the joint with 1 BOLT (R), 1 SPRING
WASHER (S),1 FLAT WASHER (T) and 1 NUT (U).
D Repeat steps B–C on the opposite side
of the elliptical.
E Slide TOP CAP over CONSOLE MAST and snap
into place.
T
S
R
F Insert CONSOLE MAST BOOT over TOP CAP
and snap into place.
ASSEMBLY STEP 6
CONSOLE
U
Nylon nut
M8
Qty:2
CONSOLE CABLES
CONSOLE MAST
WATER BOTTLE HOLDER
W
NOTE: Be careful not
to pinch any wires while
attaching the console.
HARDWARE BAG 6 CONTENTS:
V
Button head bolt
M5
Qty:4
Open HARDWARE BAG 6.
A
V
B Attach the CONSOLE CABLES to the CONSOLE.
UPPER HANDLEBAR
C Carefully tuck the CONSOLE CABLES into
the CONSOLE MAST before attaching the
CONSOLE. Attach CONSOLE to CONSOLE
MAST using 4 BOLTS (V).
PRE-INSTALLED
SET SCREWS
D Slide the RIGHT UPPER HANDLEBAR onto
the RIGHT LOWER HANDLEBAR making sure
LOWER HANDLEBAR
handlebars are joined together completely. Secure
the RIGHT UPPER HANDLEBAR to the RIGHT
LOWER HANDLEBAR using PRE-ATTACHED
SET SCREWS.
NOTE: Make sure upper handlebars are as far down
as possible. Handlebars can be damaged If not
secured correctly.
Repeat step D on the opposite side of the
E
elliptical.
F Slide WATER BOTTLE HOLDER over CONSOLE
MAST and attach using 3 BOLTS (W).
W
Button head bolt
M4
Qty:3
11