Horizon Fitness EX59 Manuel Du Propriétaire page 4

ASSEMBLY STEP 1
A
B
C
MAIN FRAME
GUIDE RAIL SET
6
HARDWARE BAG 1 CONTENTS:
A B C
Bolt Spring washer Flat washer
M10 Φ10.2 Φ10.2
Qty: 4 Qty: 4 Qty: 4
A Open HARDWARE BAG 1.
Align GUIDE RAIL SET with MAIN FRAME as
B
shown.
Attach the GUIDE RAIL SET to the MAIN FRAME
C
using 4 BOLTS (A), 4 SPRING WASHERS (B)
and 4 FLAT WASHERS (C).
ASSEMBLY STEP 2
NOTE: Be careful
not to pinch
any wires while
attaching the
console mast.
CONSOLE MAST
PRE-INSTALLED BOLTS
AND WASHERS
CONSOLE CABLE
MAIN FRAME
PEDAL ARM
CRANK
G
F
GUIDE RAIL PEDAL ARM
PEDAL ARM WHEEL
HARDWARE BAG 2 CONTENTS:
D E F
Bolt Spring washer Flat washer
Φ8.2 Φ8.2
M8
Qty: 2 Qty: 2 Qty: 2
A Open HARDWARE BAG 2.
B Carefully pull the CONSOLE CABLE through the
CONSOLE MAST using the twist tie located inside
the CONSOLE MAST.
C Attach CONSOLE MAST to MAIN FRAME using
PRE-INSTALLED BOLTS AND WASHERS.
D Slide WAVE WASHER (G) over CRANK followed
by PEDAL ARM as shown. Rest PEDAL ARM
WHEEL on GUIDE RAIL.
E Attach the PEDAL ARM to the CRANK using
1 FLAT WASHER (F), 1 SPRING WASHER (E) and
1 BOLT (D).
E
D
F Repeat steps D–E on the opposite side of the
elliptical.
G
Wave washer
Φ17.2
Qty: 2
7