Using The Alphanumeric Keypad; Alphanumeric Input; Entering Ids/Pin; Editing Values In A Table - Mettler Toledo SevenGo Duo pro pH/ORP/Ion/Conductivity meter SG78 Mode D'emploi

Operating the pH/ORP/Ion/Conductivity meter SG78

4.7 Using the alphanumeric keypad

4.7.1 Alphanumeric input

The meter has a screen keypad for entering IDs, SNs and PINs. Both numbers and letters are allowed for
these entries.
Note
When entering a PIN, each character entered will be displayed as ( * ).
a) Press
down wards.
b) Press READ to confirm the entry.
c) To end and confirm entry, use softkeys to highlight screen key OK, and press READ to save the ID.
— or —
d) To delete information, use softkeys to highlight
char ac ter.
— or —
e) Press MODE/EXIT to return to the upper level of the menu.

4.7.2 Entering IDs/PIN

The three softkeys and READ key are used for navigating on the keypad and entering the ID/PIN.
Example: WATER
a) If A is highlighted, press
b) Press
c) Press READ to enter W.
d) Repositioning the highlighted bar to A, T, E and R, and press READ to enter each letter of sample ID
in sequence as described in steps a - c.
e) Reposition the highlighted bar to OK, and press READ to save the sample ID.

4.7.3 Editing values in a table

The meter has a feature, which allows the user to enter, edit or remove values in tables. (for example,
tem per a ture and buffer values for a customized buffer group). This is accomplished by using the softkeys
on the display to navigate from cell to cell.
a) Press READ to start editing the cell in the table.
12
to move left to highlight number or letter, use
The line where the position of alphanumeric character is being entered blinks.
The entries are rejected.
V is highlighted.
once.
W is highlighted.
The softkeys on the display change.
and press READ to delete the previously entered
three times.
to move right, and
pH/ORP/Ion/Conductivity meter SG78
to move