Vaisala HMT140 Guide Rapide page 12

QUICK GUIDE ______________________________________________________________
3. Run the HMT140 Utility installation program (HMT140UtilitySetup.exe).
4. Accept the license agreement terms, then click Next to accept the installation
default settings. The installation of the driver may take several minutes.
5. After the software is installed, connect the HMT140 Configuration Cable to a
USB port on your PC to complete the installation setup.
6. When the installation is complete, disconnect the cable from your PC. You are
now ready to set up and configure your device.
If you wish to remove the Vaisala HMT140 Utility software at a later date, use the
uninstall function in the Windows Control Panel.
Set up the HMT140 Hardware
To set up the HMT140 for the first time:
1. Ensure the HMT140 Configuration Cable is disconnected from your PC.
2. Open the HMT140 case by pulling out and up with your fingers while pressing
the release tab located between the two glands with your thumb. (See the
HMT140 Components Diagram, in the Wiring and Connections section for
location of release tab). Pry case open with a slot screwdriver if you are unable
to open the case by hand.
3. Ensure the power switch on the device is in the OFF position.
4. Install three 3.6V lithium batteries as indicated on the HMT140 Components
diagram. Note: Use only part # 236318SP Vaisala 3.6V Lithium Thionyl
Chloride batteries
5. Ensure that the HMT140 Configuration Cable is not connected to the HMT140.
6. Turn the power switch on the device to the ON position, and wait for the setup
process to complete (five seconds).
Connect the HMT140 to your Network
After you install the HMT140 Utility and set up the HMT140, use the Configuration
Cable and HMT140 Utility software to connect and configure the HMT140 to your
network.
To configure the HMT140 for your network:
1. Ensure the HMT140 case is open and the correct batteries are installed (Vaisala
part #23618SP).
2. Turn on the HMT140 and wait five seconds to ensure the startup process
completes.
3. Plug the USB connector on the HMT140 Configuration Cable to the computer, if
it is not already connected.
4. From the Start menu, open the HMT140 Utility.
5. Connect the end of the HMT140 Configuration Cable labelled, USB Wi-Fi
Programmer, to the 4-pin HMT140 CONFIG header.
6. On the HMT140 Utility Setup tab, click Retrieve.
7. If the IP address is static, uncheck the IP Address Dynamically Assigned
option and enter the network parameters. Otherwise leave this option checked.
_____________________________________________________________ M211484EN-D
8
All manuals and user guides at all-guides.com