Intended Use; Changing The Abrasive Sleeve - Batavia MAXXROLL XL BT–SR002 Mode D'emploi

10. Contents
1× Maxxroll XL
1× Rubber shank for sanding sleeves
1× Sanding sleeve grain 60
1× Sanding sleeve grain 80
1× Sanding sleeve grain 120
1× Dust extraction adaptor
1× User manual

11. Intended use

The sander is designed for sanding and
polishing wood, plastic, stone, composites,
paints/varnishes, putty, and similar
materials.
Materials containing asbestos can not be
handled with the sander. The sander should
only be used for dry grinding.
The tool is to be used only for its prescribed
purpose. Any other use is deemed to be a
case of misuse.

12. Changing the abrasive sleeve

Warning! Remove the plug from the power
source before installing or removing a sand-
ing roller.
Lift the two roller end cover hasps (7)
12.1
away from the main housing (A).
A
7
9
Release the RIGHT hasp from the roller
12.2
end cover (9).
Pull the cover out from the main hous-
12.3
ing and flip it toward the front of the tool
using the LEFT hasp as a hinge.
Slide the roller (10) off the roller shaft
12.4
(5).
B
10
Remove the old abrasive sleeve and
12.5
slide the new abrasive sleeve onto the
roller.
Note: Rotate the roller sleeve counter clock-
wise as you slide the roller sleeve off or onto
the roller. Make sure it is centred on the
roller and is not overhanging one end of the
roller.
Slide the roller onto the roller shaft. Note:
The roller can only be installed one way.
When properly installed, the directional
arrow (C) on the end of the roller will be
visible.
7
Reinstall the roller end cover and fasten
12.6
it in place with the two roller end cover
hasps.
Note: Make sure the roller end cover is prop-
erly seated onto the main housing and the
hasps snap into place.
English
C
9