Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
English
13. Dust extraction
Attention: Dust resulting from sanding may
be dangerous! Therefore always use a dust
extraction system or a vacuum cleaner with
the roller sander. Connect the suction hose
to the dust extraction port (6) Avoid dust
accumulation in the work space. Dust is
easily inflammable. Dust from materials
such as lead-based paint, certain kinds of
wood, minerals and metal, can be hazard-
ous to your health. Touching or inhaling
dust can lead to allergic reactions and/ or
diseases of the respiratory tract of the user
or persons in the vicinity. Certain kinds of
dust, for example, from oak and birch wood
are considered carcinogenic, especially in
combination with additives used for the
treatment of wood (chromate and wood
preservatives).
Materials containing asbestos may only be
proces sed by experts.
• If possible, make use of the most
appropriate dust extraction for the
material.
• Ensure for good ventilation of the work
space.
• Usage of a breathing mask, filter class
P2, is advised.
Respect the regulations of your country
regarding the materials to be processed.
14. Switching ON and OFF
On/Off Switch
The ON/OFF switch (4) is a single function
switch. To turn the tool on, squeeze the
switch. To turn the tool off, release the
switch.
Lock-On Button
The lock-on button (3) is used to lock the
ON/OFF switch in the ON position. Locking
the trigger switch in the ON position will
reduce hand fatigue when operating the tool
for extended periods of time.
To lock the trigger switch in the ON
14.1
position, squeeze the on/off switch (4)
to turn the tool on.
While squeezing the on/off switch,
14.2
press the lock-on button (3) into the
handle.
10
While holding the lock-on button into
14.3
the handle, release the trigger. At this
point, the tool will remain running.
To release the lock-on button to turn the
14.4
tool off, squeeze the on/off switch (4)
and then release the on/off switch.
Attention: Make sure the lock button is not
depressed by cycling the ON/OFF switch
several times or by depressing and releas-
ing the switch several times before plugging
in your roller sander. Damage or personal
injury may result from an accidental start.
15. Speed control
The desired speed can be set with the
speed control button (2). The appropriate
speed depends on the material that will be
sanded and the sanding paper used and
needs to be determined through testing.
Attention: When using the machine contin-
uously, do not run it on the lowest speed.
This could cause overheating of the motor.
The figures in the table below are advised
values:
1 – 2
Low speed
3 – 4
Medium speed
5 – Max. High speed
16. Choice of accessory
Select the accessory according to the
shape of the surface and the material to be
processed. Adjust the grain to the desired
level of sanding.
Accessories
16.1
Rubber shank for sanding sleeves:
Purpose: Usage of sanding sleeves.
Sanding sleeve:
Material: wood, paint layers, plastics,
metals.
Purpose: Sanding down of even surfaces,
such as window frames, doors, table, etc.
Check the accessories prior to use. The
accessories must be perfectly mounted and
be able to rotate freely. Let the machine run
without any load for at least 1 minute. Do
not use damaged, non-circular or vibrating
accessories. Damaged accessories can
rupture and cause injuries.
Publicité
Table des Matières
