Before The First Use; Contents Of Packing; Intended Use; Selecting The Sanding Paper - Batavia Maxxpack BT-COS001 Mode D'emploi

English

3. Before the first use

Remove the machine and all accessories
from the package. Keep the packaging
materials out of the reach of small children.
There is a danger of suffocation!

4. Contents of packing

1× Cordless random orbital sander
1× Dust collection bag
1× Instruction manual

5. Intended use

The multi sander is intended for sanding
wood, plastic, stone, composites, paint,
filler, and similar materials.
Metal and materials containing asbestos
must not be worked with the multi sander.
The multi sander is only intended for dry

sanding.

6. Selecting the sanding paper

• Always use abrasive papers suited to the
material you want to sand. The papers
must have the correct grain size. The
grain is either Corundum or Carbide.
• Depending on grain size there are
degrees of coarseness. The coarseness
is specified by a number on the back of
the papers. The higher the number is, the
finer the grain.
• It is important to use the right paper for
each job. For rough sanding use grain
sizes up to 80, for soft wood as larch,
pine or spruce use papers from 120 to
150. For dense hardwood as beech or
maple, the grain sizes up to 220 can be
used.

7. Attaching the sanding paper

Choose the sanding paper according to the
material being worked.
Attach the sanding paper to the sanding
7.1
plate (7) and make sure the holes on
the sanding paper fit with the openings
on the base plate. Only this way the
sanding dust can be extracted through
the built-in dust removal in the sanding
plate.
Firmly press the sanding paper down on
7.2
the sanding plate.
6
8. Assembling/Disassembling/
Emptying the dust collection bag
Always use the dust collection bag (4) when
sanding.
Place the dust collection bag onto the
8.1
provided dust collection flange (5). Push
the connection piece into the flange and
turn it clockwise until it locks into place.
To remove the dust collection bag, turn
8.2
the connection piece counter clockwise
and pull it out of the flange. Preferably
clean the dust collection bag and the
exhaust connection in the housing after
each use. By doing this the dust collection
bag can be easily inserted and removed.
For emptying the dust collection bag,
8.3
just tap out or, if available, clean with
compressed air.

9. ON/OFF switch

After attaching the sanding paper con-
9.1
nect the multi sander to the dust extrac-
tion and to the mains power.
To turn the machine on, set the ON/OFF
9.2
switch (1) to I. To turn the machine off,
set the ON/OFF switch to O.
10. Sanding
• Apply only moderate pressure on the
machine. Too much pressure will lead to
jamming of the mechanism and will spoil
the result. Excessive pressure will over-
heat the machine.
• Always select abrasive paper with
coarseness suited the condition of the
surface.
• Use finer papers in the consecutive sand-
ing until the desired smoothness is
reached. If you desire a very smooth
finish you may slightly moisten the sur-
face before the last sanding. This will
slightly swell the fibres and allow a
smoother finish.

11. Cleaning and Maintenance

Cleaning
11.1
• Keep safety devices, ventilation openings
and the motor housing as free as possi-
ble from dirt and dust. Rub the electric
power tool with a clean cloth or blow
over it with low pressure compressed air.