John Bean B400 Manuel D'utilisation page 72

72
5-33
5-34
5-35
5-36
5-37
Operation
5.11.3 Start optimisation/weight
minimisation.
Procedure:
— Make sure the tyre is correctly mounted on rim and
infl ated to specifi ed infl ation pressure (mounting
guide rib of the tyre must be correctly seated).
— Clamp the wheel.
— Enter correct rim dimensions, or check existing
inputs for correctness.
— Press the START key after wheel protection
— Starting from the main menu press the menu key
F6 Optimisation menu (Fig. 5-33).
The OPTIMISATION MENU "OP.1" screen (Fig. 5-34)
is displayed.
If an optimisation/weight minimisation result has
already been saved, press the F4 key (Fig. 5-35); The
program then continues from the step 4, 6 or 10 where it
was interrupted, with the relative measurement values
and the balancing optimisation / weight minimisation
may continue.
Start weight minimisation
— Press the menu key F2 (Fig. 5-34).
The MINIMISATION "Un.4" screen is displayed (Fig.
5-36).
Start weight optimisation
— Press the menu key F1 (Fig. 5-34).
The OPTIMSATION "OP.2" screen (Fig. 5-37) is
displayed.
Continue opimisation or weight minimisation
— Press the menu key F4 (Fig. 5-35).
Resumes the previously interrupted process.
....
closing.