Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ORIGINAL OPERATING INSTRUCTIONS
DG 150 grinder with DPC20
It is essential that the operating
instructions are read before the
tool is operated for the first time.
Always keep these operating
instructions together with the tool.
Ensure that the operating
instructions are with the tool when
it is given to other persons.
Operating controls and
component parts of the DG150
³ On / off switch
· Side handle
» Guard assemby
¿ Adjusting screw
´ Clamping lever
² Indicator lamp (LED)
¶ Supply cord plug
º Speed control switch (settings 1 and 2)
¾ Side handle fastening screw
µ Clamping band
¸ Wrench
¹ Clamping nut
Diamond cup wheel
Lamellar seal, small
Clamping flange
Lamellar seal, large
Retaining ring
Spindle
Circlip
Guard lower section
©
Guard upper section with hose connector
21
©
Spindle lockbutton
22
Operating controls and component parts of the
DPC20
©
Indicator lamp (LED)
23
©
Supply cord
24
©
Guide rib
25
©
Carrying handle
26
©
Supply cord holder
27
©
Electric socket with cover
28
©
Locking lug
29
Printed: 07.07.2013 | Doc-Nr: PUB / 5069654 / 000 / 00
Contents
3. Tools and accessories
5. Safety precautions
1. General information
³ These numbers refer to the tool's operating controls
or indicators.
These numbers refer to the corresponding illustra-
tions. The illustrations can be found on the fold-out cov-
er pages. Keep these pages open while studying the oper-
ating instructions.
In these operating instructions, the DG 150 with the
DPC20 is referred to as «the tool».
Location of identification data on the tool
The type designation and serial number can be found
on the type plate on the tool. Make a note of this data in
your operating instructions and always refer to it when
making an enquiry to your Hilti representative or ser-
vice department.
Type:
Serial no.:
Type:
Serial no.:
Page
1
2
3
4
4
8
9
10
10
10
11
1
Publicité
Chapitres
Table des Matières
Dépannage
