Hilti DG 150 Mode D'emploi page 6

surface of concrete or similar mineral materials and for removing thin coatings, with a maximum thickness of 3 mm,
from these materials. The locally applicable health regulations and corresponding safety precautions must be observed
and implemented at all times while grinding coated or uncoated mineral materials with the DG150.
Do not, under any circumstances, use the tool in any way other than as described in the operating instructions.
● The tool is not suitable for grinding metals, wood or other materials not listed at paragraph 2.
● The tool is not suitable for use with diamond cutting discs, abrasive cutting or grinding discs, wire brushes or
other insert tools not approved for use (see section 3).
● The tool is not suitable for wet grinding.
● Do not clamp the tool in a vice.
● Grinding materials containing asbestos is not permissible.
● Materials containing substances hazardous to health may be ground only after consultation with the local authority
responsible for safety at work and in accordance with the locally applicable regulations concerning safety at work.
● Diamond cup wheels, clamping flanges and clamping nuts not listed in section 3 "Diamond cup wheels and acces-
sories" may not be used
● Grinding off projecting objects such as nails and screws etc. is not permissible. Such objects must be removed
carefully before beginning grinding.
Items supplied
1
1
1
1
1
1
1
3. Diamond cup wheels and accessories
Hilti item
Diamond cup wheels
DG-CW 150/6" A1
DG-CW 150/6" B1
DG-CW 150/6" C1
DG-CW 150/6" C10
DG-CW 150/6" C2
DG-CW 150/6" D1
Lamellar seals
Retaining ring
DG 150 toolbox
VCD 50L
Clamping flange for DG150
Clamping nut for DG150
Printed: 07.07.2013 | Doc-Nr: PUB / 5069654 / 000 / 00
DG 150 grinder
DPC 20 power conditioner
Clamping flange
Clamping nut
Wrench
Protective goggles
Operating instructions
Use/material
Grinding highly abrasive materials such as screed and similar mineral
materials
Grinding to remove coatings with a maximum layer thickness of 3 mm from
concrete and similar mineral materials
Grinding concrete and similar mineral materials of medium hardness and
medium abrasiveness
Grinding concrete
Grinding concrete and similar very hard and highly abrasive mineral materials
Fine finishing of concrete and similar mineral material surfaces
One large lamellar seal and one small lamellar seal
Retaining ring for attaching the large lamellar seal to the dust hood
Carrying case
Dry-type vacuum cleaner
Special quick-stop compatible clamping flange to be used exclusively
for fitting Hilti DG-CW 150/6" diamond cup wheels
Special M13 clamping nut for fitting Hilti DG-CW 150/6"
diamond cup wheels
3