Publicité
Les langues disponibles
Les langues disponibles
Interface
8.2
PC settings
- Configure the infrared interface of the Densito 30P as described in Chapter 5.6.
- Connect the adapter to an available serial interface (COM1, COM2, etc.) on
the PC.
- Insert the accompanying CD-ROM into the CD-ROM drive of the PC.
- Install the MiniTerm program.
- Start the MiniTerm program on the PC.
- Select the serial interface (Port) to which the infrared adapter is connected.
- Configure additional settings according to the figure below.
- Press the OK button on the PC.
The Connect window is closed.
8.3
Data format
If RS is selected as interface, the data is transferred in the following format:
1)
Type
,
Data column
STX
Start byte = 0
1
1
1
Type
Result
Data column
Start byte = 10
7
Type
Temperature
Data column
Start byte = 29
5
α
Type
4)
,
5)
Data column
A
Start byte = 37
1
1
1
1)
Sample identification (a...z, space)
If result is marked (*); otherwise, space
2)
Temperature unit (°C or °F)
3)
4)
Number of the temperature-compensation coefficient
The first 8 bytes contain only spaces, unless Comp. Density, SG, °Baumé or
5)
Conc. is selected as the result unit
20
2)
Sample No.
,
,
1
1
1
4
,
1
3)
,
,
1
1
1
α-value
CR
LF EOT
1
1
5
METTLER TOLEDO Densito 30P
Unit
10
1
,
1
Publicité
