Setting The Dead Band - Carson DRAGSTER SPORT Brushless-Regler Mode D'emploi

12. Setting the dead band

With the dead band setting you can adjust the speed controller to
the transmitter being used by changing the transition from forward
drive to brake action. Level 1 means a narrower transition area which
requires particularly finely tuned transmitting signals. Simple
transmitters are sufficient for the wider transition area at Level 5.
Flashing
frequency
Dead Band (%)
• Press the SET button down until the blue and red LEDs light up.
Release the SET button again.
• The blue and red LEDs start fl ashing. This shows that you are in
the mode for setting the dead band delay time.
• Press the SET button repeatedly until you reach the required
setting.
The blue and red LEDs fl ash at the next highest speed.
• By repeatedly pressing briefl y on the SET button you can scroll
through the settings.
• When you reach the required setting, hold down the SET button
for approx. 2 seconds; the setting is stored.
• Once you have stored the setting, the status LEDs fl ash one after
the other to show that you are leaving the programming mode.
The controller is ready for operation again.
• If you do not press the SET button for more than 10 seconds the
controller reverts to the last setting and is ready for use again.
CARSON DRAGSTER Brushless-Regler 906008+906056
1 2
2 3
3 4
4 5
5
GB
6
17