Important; Basic Settings On The Transmitter - Carson DRAGSTER SPORT Brushless-Regler Mode D'emploi

IMPORTANT!!!!

Before using your new DRAGSTER Brushless Controller for the first
time please note the following:
• Please read this manual carefully before using your new CARSON
DRAGSTER Brushless Controller!
• Always make sure that you have the right gear ratio. The vehicle
must not be geared low over a long period.
GB
• Only use original CARSON SHOOTER BL motors. Only use a
sensor-based motor for the Pro Controller and a sensorless motor
for the Sport Controller.
• Stop driving immediately if the cooling fan fails.
• Do not connect the battery cable (plus and minus) with reversed
polarity. The guarantee is not valid if a short circuit occurs.
• Select the correct battery type / under-voltage protection
(Cut-Off).

1. Basic settings on the transmitter

To ensure that best operation of the electronic speed controller is not
compromised by default settings on the transmitter, certain settings
on the remote transmitter should be reset before programming the
speed controller.
• Set the upper end stop for the throttle / brake servo to maximum
by selecting the highest level for the upper EPA/ATV setting.
• Set the lower end stop for the throttle / brake servo to maximum
as well by selecting the highest level for the lower EPA/ATV
setting.
• Set the trim of the throttle / brake lever to the middle position.
• Select the neutral position for the throttle / brake lever:
For training journey at e.g. 50/50 full throttle / braking
(with reverse travel)
For racing mode at e.g. 70/30 full throttle / braking
(without reverse travel)
6 CARSON DRAGSTER Brushless-Regler 906008+906056