Insert The Batteries - Carson Race Shark FD Mode D'emploi

Table des Matières

Publicité

INSERT THE BATTERIES

1. Unlock the 90° turn-lock catch (fig. 2) to open the hatch (fig. 1).
2. Insert the power-pack battery in the battery compartment (fig. 3)
and connect it to the connection plug of the model (fig. 4).
3. Take care to observe the correct polarity (fig. 4)
4. Finally, reposition the hatch cover on the hull (fig. 1) and lock it
in place with the turn-lock catch (fig. 2)
Note:
Charge the battery for the first time 4 hours, up from the second
time 2.5 hours.
Charging instructions: Attention!!!!
Important information about your rechargeable 7.2V NiMH Battery
pack. (See drawing)
1. The charging time for these 7.2V NiMH Battery pack is max. 2.5
hours, an overload damage it and shortens the life.
2. Let the charger and the battery during charging never unat-
tended.
3. If the speed / performance of your RC model decreases or even
stops, immediately stop operation and charge the battery (Note
the charge time: point 1) again.
4. To maintain the performance of the battery, please charge the
battery only when it is empty.
1
4
2
3
13 // GB

Publicité

Table des Matières
loading

Table des Matières