Selecting Forward - Brake - Backwards - Carson DRAGSTER SPORT Brushless-Regler Mode D'emploi

9. Selecting
forward – brake – backwards
Flashing
frequency
Direction of
travel
GB
• Press the SET button down until the blue LED lights up. Release
the SET button again.
• The blue LED starts fl ashing. This shows that you are in the mode
for setting the direction of travel.
• Press the SET button again briefl y. This brings you to the next
setting.
The blue LED fl ashes at the next highest speed.
• By repeatedly pressing briefl y on the SET button you can scroll
through the settings.
• When you reach the required setting, hold down the SET button
for approx. 2 seconds; the setting is stored.
• Once you have stored the setting, the status LEDs fl ash one after
the other to show that you are leaving the programming mode.
The controller is ready for operation again.
• If you do not press the SET button for more than 10 seconds the
controller reverts to the last setting and is ready for use again.
14 CARSON DRAGSTER Brushless-Regler 906008+906056
1
only forwards
"Racing mode"
2
Forwards and backwards
"Training journey"