Led Display Under Normal Operation; Controller Pre-Set Factory Defaults - Carson DRAGSTER SPORT Brushless-Regler Mode D'emploi

5. LED display under normal operation

Green LED illuminated:
Yellow LED illuminated:
All LEDs flash:
When you operate the speed controller for the first time, the under-
voltage protection (Cut-Off) is switched off as it depends on the type
of battery used. The undervoltage protection is only activated after
the battery type has been selected:
Red LED flashes:

6. Controller pre-set factory defaults

Undervoltage protection
Maximum reverse travel
Maximum braking action
Percentage drag brake when
throttle / brake lever in neutral
Dead band
Switchover
Braking / Reverse travel
CARSON DRAGSTER Brushless-Regler 906008+906056
Training mode (Reverse travel ON)
Racing mode (Reverse travel OFF)
Sensor cable loose or not connected,
Speed controller is not working! (Only
applies to sensor-based speed controller!)
Undervoltage protection on
NiCd/NiMH:
LED flashes when a battery voltage of 4 V is
reached or undershot, engine continues to
run.
Two-cell or three-cell LiPo:
LED flashes when the battery voltage of
3.0 V per cell is reached or undershot.
The engine continues to run, but only on
half power.
Discontinue using the vehicle and charge
the battery.
Off
25%
30%
10%
Level 3
After release of the brake and the
throttle / brake lever having been
taken out of neutral.
GB
11