Installation Procedures - Snap-On EEWB334A Mode D'emploi

iii-1
iii-2
1
2
5
iii-3
8
6
iii-4
iii Installation Procedures
Wheel balancer:
Supports for Accessories:
• Unpack the 4 threaded accessory support studs
• Refer to Figure iii-1. Fit the 4 threaded accessory
Threaded Shaft:
• Clean the threaded shaft and the hole in the main
• Refer to Figure iii-2. Position the threaded shaft.
• Use a pin to screw.
Clamping Devices:
• Put the clamping devices on the accessory studs.
Wheel Guard:
• Refer to Figure iii-3.
The wheel guard infl uences the following modes
of operation:
— The measuring run is started by closing the wheel
— The wheel is braked on lifting the wheel guard
Fig. iii-3
— Slide the wheel guard (1) on the arbor (2) and raise
— Insert the M10 setscrew (3) with washer (4) from
Fig. iii-4
— Connect the plug of the cable (6) with the connector
3
4
— Place the plugs loosely inside the machine through
Caution:
Since the cable is moved during opening and closing
the wheel guard, it must be passed in the band (8, Fig.
iii-4) under the wheel guard.
7
EEWB334A
Refer to the drawing in i for correct wheel balancer
positioning. If the wheel balancer needs securing,
we recommend fi xing elements with a diameter of
8 mm, quality 8.8 or higher.
and the support plates.
support studs and the plates.
axis
guard (code C 13).
during a measuring run (code C 5).
it until the fastening holes of wheel guard and wheel
guard arbor coincide.
below, and tighten the hexagon nut (5) and washer.
of the machine (7) which is projecting out of the
opening in the machine cabinet.
the hole in the machine cabinet.
61