Start Optimization/Weight Minimization - Snap-On EEWB334A Mode D'emploi

38
20
5-33
26 28
21
5-34
26
5-35
5-36
5.10.3 Start Optimization/Weight
Minimization.
Procedure:
— Clamp the wheel or bare rim.
— Enter correct rim dimensions, or check existing
inputs for correctness.
— Close the wheel guard (if necessary press the
START key).
— Starting from the BALANCING menu press key 20
Optimization – Minimization (Fig. 5-33).
The OPTIMIZATION MENU "OP.1" screen (Fig. 5-34)
is displayed.
If an optimization/weight minimization result has
already been saved, press the 21 key (Fig. 5-34);
The program then continues from the step where it
was interrupted, with the relative measurement values
and the balancing optimization / weight minimization
may continue.
At this point, you can choose whether to continue with
Optimization (Key 26), or go to Minimization (Key 28).
5.10.3.1 OPTIMIZATION
— Clamp the rim only.
— Move the gauge arm into position on the rim, based
on the desired ALU.
— Perform a measuring run.
— In the BALANCING menu press key 20 (Fig. 5-33).
The "OP.1" screen page appears (Fig. 5-34).
— Press the menu key 26 (Fig. 5-34).
The OPTIMZATION "OP.2" screen (Fig. 5-36) is
displayed.
EEWB334A