Publicité
Les langues disponibles
Les langues disponibles
Problem
Cause
Dishwasher did
1.
Did not run a sanitizing cycle.
not sanitize
2.
Opened door mid-cycle.
Dishwasher not
1.
Kinked or Crushed Drain Hose.
draining
2.
No high Loop in Drain Hose.
3.
Food Disposer plug not removed.
4.
The airgap may need cleaning (if airgap was
required during install).
5.
A home plumbing issue.
Etching
1.
Type of glass - some glassware is sensitive to
(permanent
temperature.
cloudiness)
2.
Too much detergent.
"Sudsing"
3.
Too much detergent and/or wrong type of deter-
gent and/or wrong brand of detergent.
Action
1.
Select a cycle that is intended to sanitize. See Dishwasher
cycles and options section for more information.
2.
Do not open the door while the wash cycle is running.
1.
Check Drain Hose for proper installation.
Installation Process, do not rotate the Drain Hose after it is
attached to the dishwasher. Refer to Installation Instructions
for details.
2.
Make sure that a portion of the Drain Hose is at least 33"
from the floor. Refer to Installation Instructions for details.
3.
If your Drain Hose is attached to the Food Disposer make
sure the plug in the Food Disposer was removed.
4.
Clean the air gap periodically to ensure proper drainage of
the dishwasher. With most types, lift off the chrome cover,
unscrew the plastic cap, then check for any soil buildup.
Clean if necessary.
5.
In this case, a certified plumber would need to check.
1.
Make sure that glasses are Dishwasher safe. Select a cycle
that does not get as hot. Do not use the Dry Assist option.
2.
The amount of detergent is based on the hardness of the
water delivered to your dishwasher and the amount of food
soil present. If you pre-rinse your dishes and/or have soft
water you should reduce the amount of detergent.
3.
Reduce or change the type/brand of detergent you are
using.
Note: Do not pre-rinse dishes. Scraping excess food soils is all
that is required.
22
Note: In the
Publicité
