Federal Signal Corporation 350 Instructions D'installation page 4

All manuals and user guides at all-guides.com
To minimize entry of foreign materials and moisture into the housing, ALWAYS install the
two 10-32 x 1/2" Phillips head Taptite screws in the holes opposite the mounting screws.
The Model 450 contains two red and two black wires. One set of wires (one black and one red) is used
for the incoming power. The other set should be used for the outgoing power. If the outgoing wiring is not
required, the remaining set of wires should be properly terminated. (Diagram A).
Mount the horn on the outlet box using the 8-32 x 1-5/8" screws provided, as indicated in the figure.
(Diagram B).
1. Surface Mounting
Refer to the introduction, warning message to installers, and basic installation instructions
To mount the horn on a wall or other flat vertical surface, mount a Model NB Knockout Box with
four #10 x 1" wood screws (not supplied). Connect the horn's electrical leads to the power source
with user-supplied wire nuts. Mount the horn on the NB Knockout Box with the two 8-32 x 1-5/8"
screws provided. (Diagram C).
2. Semi-flush Mounting
Refer to the introduction, warning message to installers, and basic installation instructions
A vibratory horn can be semi-flush mounted to a wall with a 4" x 4" electrical junction box when
a Model SF Wall Plate is used. If semi-flush mounting is used, a plaster ring (raised cover) may be
required. A plaster ring is not provided because the depth requirements usually vary from installa-
tion to installation.
Connect the horn's electrical leads to the power source with user-supplied wire nuts.
Use the four 6-32 x 1/4" slotted head screws to attach the SF Wall Plate to the plaster ring. Use the
8-32 x 1-5/8" screws included with the horn to mount the horn on the plate. (Diagram D).
3. Weatherproof Mounting
Refer to the introduction, warning message to installers, and basic installation instructions
Weatherproof mounting of a vibratory horn requires the use of a Model WB Weatherproof Box,
when a NEMA Type 4X rating is required. The WB is gasketed and has two 3/4" and one 1/2"
tapped openings to accommodate 3/4" and 1/2" conduit. When mounting the horn on the WB, use
the 8-32 x 1-5/8" screws included with the horn. (Diagram E).
4. flush Mounting.
Refer to the introduction, warning message to installers, and basic installation instructions
In order to flush mount the horn, a Model FB Wall Box must be installed in the wall. Use four #10
x 1" screws for mounting the box. Before installing the horn in the box, use the two 10-32 x 1/2"
Phillips head screws to attach the Model FG Grille to the horn. Connect the electrical wiring to the
horn with user-supplied wire nuts and install the horn and grille assembly in the wall box using the
two 8-32 x 2" slotted head screws provided. When installing the horn in the Model FBL Wall Box,
use the 8-32 x 3" oval head screws included with the FG Grille. (Diagram F).
nOtE
above before installing horn.
above before installing horn.
above before installing horn.
above before installing horn.
-2-