peerless-AV FPE47F-S Installation Et Montage page 13

Mounting Flat Panel Display
• Always use an assistant or mechanical lifting equipment to safely lift and position the fl at panel displays.
7 Hook adapter brackets (B) onto wall plate (J) then
slowly swing display in as shown in fi gure 7.1.
Remove 3" serrated washer head screws from
bottom of rear supports. Swing rear supports up to
access safety/security screws as shown in fi gure
7.2.
fi g. 7.1
All manuals and user guides at all-guides.com
WARNING
B
J
3" SERRATED WASHER
HEAD SCREWS
13 of 50
Turn safety/security screws, using 4 mm allen
wrench (L), clockwise at least six times to prevent
display from being removed as shown in detail 5.
NOTE: To lock the display down, tighten safety
screws to wall plate as shown in detail 5.
Route cables through ROXTEC cable seal and plug
into appropriate connection. Reinstall 3" serrated
washer head screws and locknuts to bottom of rear
supports. Tighten all fasteners.
CAUTION
• Do not postion AV and power cables close to heater
or damge to cables may occur. See next page for
more information.
B
DETAIL 5
ISSUED: 07-12-10 SHEET #: 061-9056-8 03-05-13
fi g. 7.2
J