peerless-AV FPE47F-S Installation Et Montage page 10

Reinstalling Bay Door
• Grasp bay door fi rmly. Bay door will swing freely when gas springs are removed.
If bay door was removed in step 1, lower bay door
5
onto enclosure assembly and slide to the left to
engage hinges. Align holes of center hinge with
holes of enclosure assembly (A). Reinstall two
10-24 x .5" phillips screws to inside of enclosure
assembly as shown in fi gure 5.1.
A
10-24 x .5"
PHILLIPS
SCREWS
All manuals and user guides at all-guides.com
WARNING
fi g. 5.1
10 of 50
5-1 Secure both gas springs to sides of bay door by
pressing on as shown in detail 4.
NOTE: Be sure thin end of gas spring is
attached to main enclosure assembly.
BAY DOOR
DETAIL 4
ISSUED: 07-12-10 SHEET #: 061-9056-8 03-05-13
MAIN ENCLOSURE
ASSEMBLY
GAS SPRING