Publicité
Les langues disponibles
Les langues disponibles
Installing Adapter Brackets
• Tighten screws so adapter brackets are fi rmly attached. Do not tighten with excessive force. Overtightening can cause
stress damage to screws, greatly reducing their holding power and possibly causing screw heads to become de-
tached. Tighten to 40 in. • lb (4.5 N.M.) maximum torque.
• If screws don't get three complete turns in the display inserts or if screws bottom out and bracket is still not tightly
secured, damage may occur to display or product may fail.
To prevent scratching the display, set a cloth on a fl at, level surface that will support the weight of the display.
6
Place display face side down. If display has knobs on the back, remove them to allow the adapter brackets to be
attached. Place adapter brackets (B) on back of display, align to holes, and center on back of display as shown
below. Attach the adapter brackets to the back of the display using the appropriate combination of screws, multi-
washers and spacers as shown in steps 6-1 and 6-2.
NOTE: Top and bottom holes must always be used.
Verify that all holes are properly aligned, and then tighten screws using a phillips screwdriver.
Notes:
• The number of fasteners used will vary, depending
upon the type of display.
• Multi-washers and spacers may not be used,
depending upon the type of display.
• Use the corresponding hole in the multi-washer
that matches your screw size as shown.
All manuals and user guides at all-guides.com
WARNING
CENTER BRACKETS VERTICALLY
ON BACK OF DISPLAY
B
NOTE: "X" dimensions should be equal.
11 of 50
X
X
MEDIUM HOLE FOR M5 SCREWS
SMALL HOLE FOR M4 SCREWS
LARGE HOLE FOR M6 SCREWS
ISSUED: 07-12-10 SHEET #: 061-9056-8 03-05-13
MULTI-WASHER
Publicité
