Publicité
Les langues disponibles
Les langues disponibles
EN
SETUP AND OPERATION
WARNING: Only perform adjustment operations with the tool disconnected from the power source.
CAUTION: The tool has many built in saferty interlocks. It is important that the following instructions, and those found on the label attached to
the machine are read, understood and followed. Failure to carry out the setup procedure could result in damage to the tool and/ or injury to the
operator.
Operation as Table Saw
NOTE: The 'Table Saw Mode" is optimally suited for the cutting of thin wood pieces such as laminate flooring etc.
6
Lower saw blade cover
Remove the lower blade guard and store it safely for future use. After using the saw, clean the
blade and other parts carefully and reinstall the lower blade guard to avoid accidents when not
using the tool.
WWW.NIKOLAOUTOOLS.GR
Extension wings
To hold long workpieces horizontally, holders
are provided on both sides of the tool. Loosen
the screws and extend the holders to the
appropriate length for holding the workpiece.
Then tighten the screws.
1. Screw off the knobs on the right and left side by hand.
2. Raise the table top to its upmost position and tighten the
height adjustment screw.
NOTE: The cutting thickness must not exceed 30 mm.
3. Connect the plug to a suitable socket.
4. Turn the switch on.
5. Put the workpiece on the table, and move
it forward, along the direction pointed by
the arrow.
6. Use the parallel guide to adjust the cutting
length accordingly.
Publicité
