BorMann BDX2150 Mode D'emploi page 5

BEFORE OPERATION
WARNING: Always disconnect the tool from the power source before making any adjustments.
Permanently mounting table saw & blade
WARNING: To reduce the risk of injury from unexpected saw movement, place the saw in the desired area either on a work bench or other
recommended leg set. The base of the saw has four holes to mount the table saw. If the saw is to be used on location, permanently fasten it to
the work bench or leg set using appropriate bolts with lock washers and nuts.
NOTE: When permanently mounting the saw it is recommended that the four rubber feet located underneath each of the mounting holes are removed and
stored safely for possible future use.
1. Tighten the miter and bevel locks.
2. Position the saw in such way that other people cannot stand behind it. Thrown debris could injure bystanders.
3. Place the saw on a firm, level surface where there is plenty of room for handling and properly supporting the workpiece.
4. Support the saw so that the table is level and the saw does not sway.
5. Bolt or clamp the saw to its support.
1. Hex headed bolt 6. Flat washer
2. Spring washer 7. Spring washer
3. Flat washer 8. Hex nut
4. Miter saw base 9. Lock nut
5. Workbench NOTE: THESE PARTS ARE NOT INCLUDED.
U-Shaped support pole
It is located behind the power tool. Use it to support the tool and prevent it from falling backwards
while using it. Adjust the distance properly, according to your needs. The length can be adjusted
from 23mm to 93mm long.
Workpiece clamps
Two sockets, one on each side, are incorporated into the rear of the tool's fence.
1. Fit the pillar of the clamp into the socket that best suits your cutting application, making sure
that it is pushed down fully.
2. Tighten the fence thumbscrew to lock the pillar of the clamp into the fence socket.
3. Put the workpiece onto the rotary table and against the fence.
4. Adjust the clamp so that it securely holds the workpiece to the rotary table.
5. Before attempting any cutting, check to make sure that the clamp does not interfere with the
blade's path when the cutting head is lowered.
Position plate
When the workpiece is longer than the work table, you can use the position plate.
1. Unscrew the knob behind the position plate and push the plate in the direction of the arrow until
it stops and reaches the terminal position.
2. Screw the knob and fasten the plate.
The position plate and the workpiece clamps are used in combination to provide a more user-
friendly operation and reduce the risk of injury.
WWW.NIKOLAOUTOOLS.GR
EN
5