Publicité
Les langues disponibles
Les langues disponibles
26
www.electrolux.com
Step 5
Step 6
Step 7
Step 8
Step 9
If the door is installed correctly, you will hear a click when closing the latches.
The screen-printing zone must face the
inner side of the door. Make sure that
after the installation the surface of the
glass panel frame on the screen-printing
zones is not rough when you touch it.
When installed correctly the door trim
clicks.
Make sure that you install the internal
glass panel in the seats correctly.
12.5 How to replace: Lamp
WARNING!
Risk of electric shock.
The lamp can be hot.
Turn off the oven. Wait un‐
til the oven is cold.
Hold the door trim (B) on the top
edge of the door at the two sides
and push inwards to release the
clip seal.
Pull the door trim to the front to
remove it.
Hold the door glass panel by its
top edge and carefully pull it out.
Make sure the glass slides out of
the supports completely.
Clean the glass panels with water and soap. Dry the glass panels careful‐
ly. Do not clean the glass panels in the dishwasher.
After cleaning, install the glass panel and the oven door.
Before you replace the lamp:
Step 1
Disconnect the oven from
2
B
Always hold the halogen lamp with a
cloth to prevent grease residue from
burning on the lamp.
Step 2
the mains.
1
Step 3
Put a cloth on the bottom
of the cavity.
A
Publicité
