Description of parts
1. Gearmotor
2. Gate bracket and fastening screw
3. Post bracket and fastening screw
4. Bushing for post bracket
5. Release key
6. Cover 1
7. Cover 2
Standard installation
1. Gearmotor
2. Control panel
3. Transmitter
4. Key-switch selector
5. Flashing light
6. Photocells
7. Junction pit
8. Mechanical gate stops
GENERAL INSTRUCTIONS FOR INSTALLING
Only skilled, qualified staff must install this product.
Preliminary checks
⚠ Before beginning, do the following:
• check that the gate is stable and that the hinges are in good working order and lubricated;
• check that distance C does not exceed the reference-table value;
• make sure there are opening and closing mechanical gate stops;
• make sure that the point where the gearmotor is fastened is protected from any impacts and that the surface
is solid enough.
• make sure you have set up a suitable dual-pole cut off device along the power supply that is compliant with the
installation rules. It should completely cut off the power supply according to category III surcharge conditions
(that is, with minimum contact openings of 3 mm);
•
make sure that any connections inside the container (ones that ensure continuity to the protection circuit) are
fitted with additional insulation with respect to those of other electrical parts inside:
• set up suitable tubes and conduits for the electric cables to pass through, making sure they are protected from
any mechanical damage.
④
M8 x 35
UNI 7474 M8
⑤
⑥
④
②
⑦
②
⑥
③
①
⑧
⑥
⑦
①
⑤
⑥
⑥
①
⑧
③