Rosenbauer HEROS-titan Info Pour L'útilisateur page 38

Rosenbauer – HEROS-titan
8. REPAIR INSTRUCTIONS
8.1 Chinstrap replacement
As described in Section 5.2, the chinstrap can be removed using an Allen key and
then reinserted using the reverse procedure. The chinstrap is then to be properly
adjusted as explained in Section 4.3.
8.2 Visor replacement
Firstly, the two screws (hexagonal socket) must be loosened.(see Fig. 15/16) The
visor should then be removed from its anchorage (see Fig. 17).
A new visor is then inserted, between helmet strap and helmet shell onto the
seating bolts and the supports pushed into the plastic lugs. These are then
secured by the holding screws. (WARNING: Take care that the enclosed spring
washers sit properly!)
15
8.3 Eye protection visor
replacement
To change out the eye
protection visor, disas-
sembling the inner lining
as described under point
4.2.1 is recommended.
(see Fig. 18 and 19). Sub-
sequently, loosen the two
holding screws (hexago-
nal socket) of the eye protection visor anchorage and exchange the visor. Then re-
install the entire interior harness using the reverse procedure.
8.4 Replacement of the complete interior harness
As described in Section 4.2.1, loosen the four fixing points, remove the shaft of
the mechanism from the turning knob and then take the entire interior harness
out of the helmet. Reinsertion takes place using the reverse procedure.
38
16
18
17
19