Rosenbauer HEROS-titan Info Pour L'útilisateur page 30

Rosenbauer – HEROS-titan
3.5 Neck protection
All the materials employed are flame retardant and highly heat-resistant. The neck
guards are secured to the interior helmet harness and the helmet shell by a
tension strip and are easily removed for cleaning purposes. The neck guard offers
generous cover for the neck and ear areas without reduction of the hearing. Neck
protectors are wear parts; a sufficient number should be kept in stock. The
"Holland" all-round neck protection is optionally available in place of the standard
neck protection.
WARNING: The neck guard is a protective device, made of soft, flexible material, which
offers limited mechanical protection. Neck guards are wear parts and should be
stocked in sufficient quantities. In operations in which a flashover or a similar event is
to be expected, we strongly recommend that all-round neck protection and a flame
protection hood be used.
4. INSTRUCTIONS FOR USE
4.1 Helmet size adjustment
A basic helmet setting can be established as a result of the unique possibility provided
for adjusting the headband to the respective head size from the outside.
The setting screw on the outside of the helmet can be used to adjust the size from 49
to 67; if the head size is smaller, the basic width of the headband can also be adjusted.
Open the helmet harness, put the helmet on and tighten the harness until the helmet
sits firmly, without a feeling of excessive pressure.
Putting on the helmet
30
Size regulator to be turned on to „minimum"