Rosenbauer HEROS-titan Info Pour L'útilisateur page 33

4.4 Chinstrap adjustment
The chin strap can be adjusted on two sides.
Tight fit on the chin (see Fig. 9).
Position of the chin strap padding near the ears (see Fig. 10).
9
NOTE: In general, the straps should be tensioned in such a way that they fit tightly, but
provide comfortable wear.
NOTE: This helmet complies with the retention requirements of the relevant standard
and will only provide optimum protection if the chin strap is adjusted and closed as
instructed. Helmets must be used only with chinstraps fully closed and adjusted to a
tight fit.
4.5 Adjustment of the helmet center of gravity
Optionally, the helmet can be optimally aligned to
the body's center of gravity by moving the helmet
shell relative to the interior fittings.
To do so, open the main fittings left and right as
shown in Fig. 12. The inside liner can then be
adjusted to one of the three possible "A B C"
positions. Be sure to adjust both sides equally.
10
HEROS-titan – Rosenbauer
11
12
EN
33