Rosenbauer HEROS-titan Info Pour L'útilisateur page 34

Rosenbauer – HEROS-titan
4.6 Adjustment wearing comfort headband
The wearing comfort can now be adjusted at any
time using the external rotary knob (see Fig. 13) -
very easily, even when wearing fire fighting gloves.
4.7 Visor
The visor is attached to the front edge of the
helmet and should be pulled down until it stops
(see Fig. 14). The visor is pushed up in the reverse
sequence. The optional eye protection visor is
pulled down until it stops using both lateral levers
simultaneously. It is pushed up in the reverse
sequence, but is only secure when tangible locking
occurs.
WARNING: The protective function of the visors is ensured only in the end position
(final stop, no intermediate position). Improper use of the visors can lead to serious
injury or even death. Damaged visors may no longer be used and must be replaced
immediately.
5. CARE INSTRUCTIONS
The outer layer of the helmet, the plastic parts and the inner lining must be cleaned
periodically. It is best if the outer layer of the helmet is cleaned after every operation;
this reduces the ability of the dirt to stick. Clean the outer layer of the helmet and the
plastic parts solely with water, a mild plastics cleaner or dishwashing liquid, and a soft
cloth. Rinse visors with water before cleaning and clean them using a mild dishwashing
liquid or similar and a soft cloth.
CAUTION: Do not use any abrasive sponges or similar!
WARNING: Never clean any part of the helmet or visor with solvents, petrol, acids,
etc., as this can have negative effects on the protective function.
34
13
14