7.2 Hob
Selecting the burner
CAUTION!
The flame must not spread over the edges of the cookware. Place the
cookware centrally on the burner, so that it is stable on the support grid.
Electronic ignition of the hob
CAUTION!
Ignition must be done without any cookware or other object on the
burners.
h
To generate the flame, fully press down the control knob (Fig. 5 6, page 10)
and turn it to the large flame position (Fig. 5 2, page 10).
h
Simultaneously push down the electronic ignition button (Fig. 5 5, page
10).
Once the flame has been generated, press the knob down for a few seconds so
h
that the flame remains lit.
CAUTION!
If the burner does not turn on:
● turn the knob to the small flame position (Fig. 5 3, page 10);
● proceed with manual ignition;
● check that there is gas in the cylinder.
If the device does not work, close the gas inlet tap and contact your
dealer.
EN
BURNER
AUXILIARY
Ø 47 mm
SEMIRAPID
Ø 62 mm
RAPID
Ø 77 mm
COOKWARE
DIAMETER
from 60 mm to 160 mm
from 160 mm to 220 mm
from 160 mm to 220 mm
Use
39