Spare Parts; Electrical Diagram; Disposal; Ce Declaration - PLYMOVENT MDB-2/HV Manuel D'installation Et D'utilisation

symptom Problem
Green control Wrong status
light indication
ruNNING
is off, but fan
is running
Dust from System is
dustbin leaking
The system System not
does not start working
8

sPaRE PaRTs

The following spare parts are available for the product (refer to
exploded view Fig. VI on page 22).
article no. description
0000100297 CART-PTFE/10 / Filter cartridge
0000101900 Magnetic valve MDB, incl. 24V AC coil and 3 m (10 ft)
cable
0000102411 Drain valve ½ inch MDB
0000102584 Lock kit for filter cartridge
0000102598 Star knob M12
0000102666 Lid for filter cartridge
0000102675 Filter cartridge holder
0000111381 DB-80 / Dustbin 80 litres, incl. lifting pin and handles
0000111622 Lid for dustbin DB-80
0324000310 Control light green 24V
0324000320 Control light red 24V
A [on request] HV fan
B [on request] Cooling fan
9

ElECTRiCal diagRam

Refer to the separately supplied electrical diagram.
10

disPOsal

Dismantling and disposal of the unit must be done by qualified
persons.
Personal protective equipment (PPE)
Wear respiratory protection and protective
gloves when you dismantle and dispose of
the unit.
0000112315/011017/0 MDB-2/HV
Possible cause solution
Status indicator Replace green light
light is broken
Quick connect Install the quick
clamp not connect clamp
correctly correctly
installed
System turned Turn the
PROGRAM
off by button
PROGRAM ON/OFF
button.
ON/OFF
Main switch Turn on the main
turned off switch
Wrong date / Correct the date /
time setting in time setting (ref.
PlC Fig. III on page
20)
Wrong weekly Correct the weekly
timer setting in timer setting (ref.
PlC Fig. IV on page
21)
System has Reprogram current
been powered date and time in
down (no mains the PLC (ref. Fig.
during 80 III on page 20)
hours)
Install a battery
pack and
reprogram current
date and time to
avoid future
problems
10.1 dismantling
To safely dismantle the unit, obey the safety instructions that
follow.
Before dismantling of the unit:
- disconnect it from the mains
- disconnect it from the compressed air
- clean the outside
During dismantling of the unit:
- make sure that the area is sufficiently ventilated, e.g. by a
mobile ventilation unit
After dismantling of the unit:
- clean the dismantling area
10.2 disposal
Dispose of the pollutants and dust, together with the used
filter cartridges, in a professional manner in accordance with
federal, state or local regulations.

CE dEClaRaTiON

CE declaration of conformity for machinery
We, Plymovent Manufacturing B.V., Wezelkoog 11, 1822 BL
Alkmaar, the Netherlands, herewith declare, on our own
responsibility, that the machine:
- MDB-2/HV
which this declaration refers to, are in accordance with the
conditions of the following Directives:
- Machine Directive 2006/42 EC
- EMC 2014/30 Eu
- lVD 2014/35 Eu
- ErP Directive 2009/125 EC
Alkmaar, Netherlands, 1 October 2017
M.S.J. Ligthart
EN - 10